Description:

• Spraying distance up to 6-9 meters.
• Have total flexibility and maneuverability.
• Manual control method, no power supply needed.
• High-quality material, good effect, and long service life

Specification :

•  Output: high output carbon dioxide gas
•  Control Mode: DMX512/Electronic Control
•  Channels dmx: 1-channel co2 spray (0-255) on
•  Connectable: dmx/power in/out (power con with key)
•  Voltage: AC110V / 220V, 60Hz / 50Hz
•   Power: 30w
•   Spray height: 8-10 meters
•   Maximum pressure: 1400Psi
•   Hose length: Request specific length needed
•   Angle: Adjustable from 0 to 90 degrees
•   Product Warranty Time: 1 year
•   Packaging Shape: Cardboard box with foam inside, or Roadcase
•   Product dimensions: 27*20*39 cm
•   Packaging dimensions: 30*30*42 cm
•   Product weight: 5.2 kg
•   Shipping weight: 8 kg

INSTALLATION：

1. place the large CO2 column in the corresponding position.
2. connect the c02 hose to the gas bottle
3. connect the machine with the gas bottle through the hose, the hose on one side connects to the tank, and the other side connects to the machine.
4. connect the valve of the gas bottle, then connect the machine and the console
5. Before disassembling, first turn off the bottle valve, let out the gas remaining in the tube, then turn off the power, and finally separate the gas bottle connector.

STEPS TO USE :

1. Electric control: The operation of the machine is very simple Connect the Co2 cannon to the electric control button, Then connect the machine to the Co2 gas tank via a high-pressure hose Switch the machine to the “ON” position, open the valve of the cylinder. Press the control button, the machine will spray.
2. DMX512 control: Connect the Co2 jet cannon to the power supply via the power cable, and DMX to the DMX controller via the DMX cable Then connect the machine to the Co2 gas tank via a high-pressure hose, Switch the bottom to”DMX position, the machine has only one channel. After setting the DMX address, operate your console, The machine will spray.
3. In order to ensure that the machine parts have a normal service life. it is recommended to control the continuous spraying time at about 10 seconds each time When the machine is not needed, and if the high-pressure pipe needs to be removed. it needs to be sure to turn off the gas cylinder switch first, and then evacuate the residual gas in the machine before removing the tube, otherwise, either end of the tube and the gas cylinder cannot be pulled out.